Show page

Differences

This shows you the differences between two versions of the page.

--- iothings:proiecte:2021:alexa-system [2022/01/25 00:09]
adriana.ionita2404
+++ iothings:proiecte:2021:alexa-system [2022/01/27 02:35] (current)
adriana.ionita2404
@@ Line 3: / Line 3: @@
 Adriana Ionita - AAC \\
 E-mail: adriana.ionita2404@stud.acs.upb.ro
+{{ :iothings:proiecte:2021:alexa_intro.jpg?500 |}}
 ==== Description ====
@@ Line 43: / Line 46: @@
 ==== Final result ====
+=== Hardware setup ===
 The project has been successfully implemented and set in position:
-<TODO: add images>
+{{https://ocw.cs.pub.ro/courses/_media/iothings/proiecte/2021/alexa_hw_1.jpg?600}}
+Some wires were hidden to try to make it look nicer:
+{{https://ocw.cs.pub.ro/courses/_media/iothings/proiecte/2021/alexa_hw_2.jpg?600}}
+Good thing it's all covered up :)
+{{https://ocw.cs.pub.ro/courses/_media/iothings/proiecte/2021/alexa_hw_3.jpg?600}}
+=== WiFi Light & WiFi Fan registration ===
 In order to get started, the devices have to be registered using the Alexa App:
@@ Line 52: / Line 67: @@
 {{https://ocw.cs.pub.ro/courses/_media/iothings/proiecte/2021/alexa_setup_devices.png?600}}
-It has been tested and it works properly with both the Alexa App and the Echo Dot.
+After the registration is complete, the 2 devices will be available in the "Lights" section of the application under the names "WiFi Light" and "WiFi Fan". From there they can be controlled with Alexa.
-<TODO: add images>
+=== WiFi Light usage ===
 The Alexa library for Arduino is designed especially for lights. So using it to control the lights of this project was pretty straight forward because it implied to use this library as intended. Functionality for the lights include turning lights on/off, setting the brightness and setting the color:
@@ Line 60: / Line 75: @@
   * using the Alexa App installed on my phone.
-<TODO: add images>
+{{https://ocw.cs.pub.ro/courses/_media/iothings/proiecte/2021/alexa_light.png?600}}
+=== WiFi Fan usage ===
 For the fan on the other hand, I had to adapt these mechanisms available for lights to obtain the functionality I needed. Also, the fan is tightly dependent on the temperature sensor. So this is the behaviour for the fan and the sensor:
@@ Line 73: / Line 90: @@
     * Any other colour: always off, regardless of the temperature
-<TODO: add images>
+{{https://ocw.cs.pub.ro/courses/_media/iothings/proiecte/2021/alexa_fan.png?600}}
+=== Demo ===
 The functionality of the project is also demonstrated in the video below:
-<TODO: add video>
+[[https://youtu.be/dYg_C0Q1hfU|{{https://ocw.cs.pub.ro/courses/_media/iothings/proiecte/2021/alexa_thumbnail.jpg?600|}}]]
 ==== Resources ====