Differences
This shows you the differences between two versions of the page.
|
pm:prj2026:bianca.popa1106:mihai.brisculescu [2026/05/28 01:42] mihai.brisculescu [Download] |
pm:prj2026:bianca.popa1106:mihai.brisculescu [2026/05/28 16:17] (current) mihai.brisculescu [4. Audio Output — Triple I2S Architecture] |
||
|---|---|---|---|
| Line 246: | Line 246: | ||
| <note warning> | <note warning> | ||
| **Required breakout rework:** The Adafruit 3006 breakout (and clones) includes a 1 MΩ SMD pull-up between ''SD_MODE'' and the chip's V_DD (5 V). This must be **desoldered from each breakout before installation** — otherwise the GPIO LOW state would fight the pull-up and shutdown never engages. Once removed, only the chip's internal 100 kΩ pull-down remains. | **Required breakout rework:** The Adafruit 3006 breakout (and clones) includes a 1 MΩ SMD pull-up between ''SD_MODE'' and the chip's V_DD (5 V). This must be **desoldered from each breakout before installation** — otherwise the GPIO LOW state would fight the pull-up and shutdown never engages. Once removed, only the chip's internal 100 kΩ pull-down remains. | ||
| - | |||
| - | **Do NOT bridge any breakout channel-selection solder jumpers** (''L'', ''R'', ''Mono''). If bridged, they hard-tie ''SD_MODE'' to the chip's 5 V VDD, and driving the GPIO LOW would short 5 V to GND through the 3.3 V GPIO pin and damage the Teensy. | ||
| </note> | </note> | ||
| Line 705: | Line 703: | ||
| </note> | </note> | ||
| + | * Firmware source code: [[https://github.com/MidsoftEntertainment/MiniSynth-public|MiniSynth Public Repo]] | ||
| * Full schematic: {{:pm:prj2026:bianca.popa1106:minisynth_brisculescu.pdf|MiniSynth.pdf}} | * Full schematic: {{:pm:prj2026:bianca.popa1106:minisynth_brisculescu.pdf|MiniSynth.pdf}} | ||
| - | * Example loop: {{:pm:prj2026:bianca.popa1106:loop_002.wav|}} | + | * Example loop: {{:pm:prj2026:bianca.popa1106:loop_002.wav|LOOP_002.WAV}} |
| ===== Journal ===== | ===== Journal ===== | ||
