Show page

Differences

This shows you the differences between two versions of the page.

--- pm:prj2025:iivasciuc:131375 [2025/05/30 10:42]
mircea_ovidiu.dodi [Bibliografie/Resurse]
+++ pm:prj2025:iivasciuc:131375 [2025/05/30 10:45] (current)
mircea_ovidiu.dodi [Arduino Pinout:]
@@ Line 92: / Line 92: @@
   * SCL: A5 (Fixed for I2C)
-Power Connections
+Power Connections:
 VCC (5V)
   * LCD Display
-  * RFID Module
   * Servo Motor
   * Load Cell
   * Keypad
+VCC (3.3V)
+  * RFID Module
 GND
@@ Line 147: / Line 150: @@
 <note tip>
-The intended functionality was achieved - a demo can be found on the following [[https://www.youtube.com/watch?v=Mho3pYF5UIk&ab_channel=MirceaOvidiu|YouTube]] link or embedded in the [[https://github.com/MirceaOvidiu/SmartLocker|GitHub]] page.
+The intended functionality was achieved (except the load cell feature) - a demo can be found on the following [[https://www.youtube.com/watch?v=Mho3pYF5UIk&ab_channel=MirceaOvidiu|YouTube]] link or embedded in the [[https://github.com/MirceaOvidiu/SmartLocker|GitHub]] page.
 </note>
@@ Line 183: / Line 186: @@
 {{:pm:prj2025:iivasciuc:smartlockerfinal.jpg?nolink&300|}}
-===== Bibliografie/Resurse =====
+===== Bibliography =====
 <note>
-Listă cu documente, datasheet-uri, resurse Internet folosite.
-Resurse:
+Resources used:
 [[https://www.instructables.com/Arduino-Wiring-and-Programming-of-RFID-Sensor/| RFID guide]]
@@ Line 198: / Line 200: @@
 [[https://randomnerdtutorials.com/arduino-load-cell-hx711/| Load cell and HX711 module tutorial]]
+[[https://arduinogetstarted.com/tutorials/arduino-lcd-i2c| I2C display configuration]]