Differences
This shows you the differences between two versions of the page.
|
pm:prj2023:tmiu:gasdetector [2023/05/21 23:05] aionita1001 |
pm:prj2023:tmiu:gasdetector [2023/05/29 23:56] (current) aionita1001 [Hardware Design] |
||
|---|---|---|---|
| Line 17: | Line 17: | ||
| *Breadboard | *Breadboard | ||
| *Arduino UNO | *Arduino UNO | ||
| + | *10kOhm Potentiometer | ||
| *16x2 LCD Screen | *16x2 LCD Screen | ||
| *MQ-2 Gas Sensor | *MQ-2 Gas Sensor | ||
| - | *Resistances | + | *2 * 220Ohm Resistances |
| - | *Batteries | + | |
| *Wires | *Wires | ||
| | | ||
| + | </note> | ||
| {{:pm:prj2023:tmiu:gasdetector_tinkercad.png?200|}} | {{:pm:prj2023:tmiu:gasdetector_tinkercad.png?200|}} | ||
| - | </note> | + | |
| ===== Software Design ===== | ===== Software Design ===== | ||
| - | |||
| - | |||
| <note tip> | <note tip> | ||
| The following software was used in order to write the code: | The following software was used in order to write the code: | ||
| Line 35: | Line 34: | ||
| </note> | </note> | ||
| - | ===== Rezultate Obţinute ===== | + | ===== Download ===== |
| <note tip> | <note tip> | ||
| - | WIP | + | The code can be found here: |
| - | </note> | + | {{:pm:prj2023:tmiu:gas_detector_iam.zip|}} |
| - | + | ||
| - | ===== Concluzii ===== | + | |
| - | + | ||
| - | ===== Download ===== | + | |
| - | + | ||
| - | <note warning> | + | |
| - | WIP | + | |
| </note> | </note> | ||
| Line 54: | Line 46: | ||
| 7th of May 2023 | 7th of May 2023 | ||
| *Initial documentation was written. | *Initial documentation was written. | ||
| + | 21st of May 2023 | ||
| + | *Added Tinkercad schematic | ||
| + | 28th of May 2023 | ||
| + | *Added code | ||
| </note> | </note> | ||
