We’ll be using ROS2 (Robot Operating System) throughout this course. ROS2 provides tools, libraries, and conventions that facilitate building robotic applications and allow different parts of the robot to interact with each other.

Familiarize yourself with the basics of ROS by reviewing the ROS introduction guide (https://wiki.ros.org/ROS/Introduction). Keep this guide handy as a ROS2 cheat sheet (https://github.com/ubuntu-robotics/ros2_cheats_sheet/tree/master) that you can refer to throughout the course. We also have a list of important ROS2 commands for this course here: What is ROS 2?

ROS services in Pupper: robot.service manages control code (face controller, rl or heuristic controller, etc). See if controller is running: systemctl status robot.service You should see the status as “active (running)”. Checkout all topics and services: ros2 topic list and ros2 service list.

Since we are running custom code, we must disable the robot service before working on your code. This will prevent the robot from running any pre-existing code that may interfere with your work. Make sure to place Pupper on the stand during this process. To disable the robot service, run the following commands:

Note: Robot Service should already be disabled. So you can skip this step and proceed to Part 2.

sudo systemctl disable robot.service
sudo reboot

• Open the lab 1 code repository (https://github.com/cs123-stanford/lab_1_fall_2025) on your GitHub account. Then, fork the repository to your own GitHub account.

• Open the lab 1 folder in VSCode

cd ~/lab_1_fall_2025
code .

• Examine lab_1_fall_2025/lab_1.py to understand where the motor angle and velocity are read and where the motor is commanded.

DELIVERABLE: Before running your code, explain in your lab document what you understand about the publishers and subscribers. What gets sent and received on each message publish? How does this correspond to what is physically commanded in the motor?